Set-Up Location Requirements - Silvercrest IUK 5 A1 - IAN 48807 Bedienungsanleitung

NOTE
► If possible, keep the original packaging of the device for the warranty period so that the device
GB
can be packed properly for return shipment in the event of a warranty claim.

Set-up location requirements

For safe and trouble-free operation of the device, the set-up location must fulfi l the following requirements:
■ Set up the device on a fi rm, fl at and horizontal surface.
■ The surfaces of some items of furniture might contain components that can corrode and soften the
rubber pads of the device. If necessary, place a cover under the device's pads.
■ Or install the device using the mounting materials
mounting arm
■ After you have attached the mounting arm
screw (A) into the thread
■ If required, loosen the screw connection (B) to adjust the angle of the mounting arm
retighten the screw connection (B) so that the camera is held securely on the mounting arm
■ Operate the device only in dry locations, never in a hot environment or anywhere near fl ammable
materials.
■ Operate the device only in locations with adequate ventilation.
10
onto the wall as shown in the following diagram.
on the bottom of the camera base
that are included in the delivery to fi x the
with the screws and wall plugs
.
, turn the hand
. Then
.
IUK 5 A1