Invacare Aquatec Pure Gebrauchsanweisung Seite 22

Aquatec® Pure Bidet
remain longer than 30 minutes on the seat, the seat
temperature drops automatically. As soon as you leave the
seat, the temperature returns to the setpoint.
Setting warm air temperature
The warm air temperature can be set in five steps:
1. Press DRY button E on the remote control.
2. Press HIGH respectively LOW button J on the remote
control.
• The temperature of the warm air dryer is raised or
lowered by one step and displayed on the LED A.
The last value of the warm air dryer temperature is
automatically saved by the device.
Turning on/off night-light LED
1. Press LIGHT button M on the units control panel.
• The night-light is activated when it gets dark in the
room.
When the night light is activated, the device
automatically recognizes the toilet light and the night
light is turned off. The user can conveniently bidet
without toilet light. The power consumption of the
night-light is very low.
2. Press LIGHT button again to switch off the night-light.
22
Automatic power saving mode
1. Press POWER SAVING button L repeatedly, until "AUTO"
LED Q illuminates.
• Seat temperature is automatically set at 30 °C
Auto power saving function is temporarily released,
when sitting on the seat. Auto power saving function
runs again, when moving away from the seat.
2. Press POWER SAVING button twice.
• Power saving mode deactivates and "AUTO" LED
turns off.
Super power saving mode
Bidet senses toilet luminosity for itself and shows excellent
power saving function.
1. Press POWER SAVING button L repeatedly, until
"SUPER" LED R illuminates.
• Water and seat temperature maintain normal
temperature.
Power saving mode is temporarily released when
toilet light turns on. It returns to normal mode from
power saving mode even if occupying the seat in
dark condition.
2. Press POWER SAVING button once.
• Power saving mode deactivates and "SUPER" LED
turns off.
1590625-D