Assembling Concealed Cistern - Invacare Aquatec Pure Gebrauchsanweisung

Preparing the remote control
A
1. Remove battery cover A from remote control.
2. Insert batteries B. Ensure correct polarity.
3. Close battery cover of remote control.
4. Place remote control D into its holder C.

4.2 Assembling concealed cistern

Installing water flow over angle valve
1. Connect angle valve and bidet with the PVC Flexible
hose (accessory).
2. Turn the water tap on.
IMPORTANT!
– Check the connection for leaks and re-fit if
necessary.
Installing water flow over flush-mounted housing
1590625-D
B
A
C
1. Remove the push plate from the flush-mounted housing.
2. Remove the rear cover plate to obtain a direct
perspective on the connection.
3. Turn the water tap off.
4. Remove connecting sleeve D and replace by T-piece E.
5. Connect T-piece with PVC Flexible hose C.
6. Connect PVC Flexible hose with tube A using nut B.
7. Connect tube A with pure bidet.
8. Turn the water tap on.
IMPORTANT!
– Check the connection for leaks and re-fit
if necessary.
9. Cut-out inner cover plate F, mounting plate G and
push plate H according to the figure above taking into
account the indicated dimensions [mm].
10. Re-attach the inner cover plate and the mounting plate
inside the flush-mounted housing.
11. Close flush-mounted housing with the push plate.
Following parts are needed for the assembly of the
flush-mounted water flow but are not included in
the scope of delivery:
• Tube A
• Nut B
Available at your specialised dealer.
Setup
15