Automatic Address Allocation With Transponder; Manual Address Allocation Via Reader Keypad - Honeywell Accentic Montage- Und Bedienungsanleitung

Mounting and Operating Instructions - proX2-reader "Accentic" with keypad
6.2.5

Automatic address allocation with transponder

The address allocation mode must be activated.
Hold a transponder e.g. chipcard or key fob) in the reading range The
unique number (serial number) to the
and transmits the unique number plus the address back to the
reader stores the address
Address acknowledgement: After approx. 1 sec. the LEDs indicate the allocated address (see
6.2.3).
ACS-8
allocates a free
address to the
unique number
For further operating
sequences, see "NetEdit"
6.2.6

Manual address allocation via reader keypad

The address allocation mode must be activated.
When using this allocation mode, a specific address can be allocated to a
reader on site. The plausibility check in the AC system prevents an
address from being allocated more than once.
Note:
- Every activated key is acknowledged by a click.
- An address entry can be rejected by an .
Enter the new address with 1 or 2 digits and acknowledge with OK (key
The address is transmitted to the ACS-8 and checked.
Positive acknowledgement
After remaining blank for approx. 1 sec. the LEDs indicate the newly
allocated address (see 6.2.3).
Negative acknowledgement
If the address is already occupied, it is not allocated to the reader and there is no address displayed.
Change address
Enter new address with 1 or 2 digits and acknowledge with OK. (Acknowledgement and display as
described above). All allocated parameters are transmitted from the old address to the new one so
that the old address can be re-allocated.
(
ACS-8
permanently .
Unique number
Unique number
+ address
. The ACS-8 allocates a free address to this number
F i
1 2 3
4 5 6
7 8 9
3
r
0
X
. reader now transmits the
reader . After a brief interval, the
or other
transponder
1
4
7
r
3
).
Delete
Reject
25
2 3
5 6
8 9
3
0
Confirmation
OK