Jomox T-RACKONIZER Bedienungsanleitung Seite 9

LFO Rate:
This parameter controls the LFO frequency (period) and ranges from
approximately 0.15Hz (7sec) to about 22Hz (45ms).
If the LFO Rate is set very low and the LFO Intensity is turned to the left,
the envelope alone determines the resulting modulation signal, so it is
possible to seamlessly adjust between a pure envelope signal and an LFO-
modulated envelope signal.
L F O R a te s m a ll
L F O R a te = 0
Env Amt 1:
This knob determines how the envelope signal modulates the cutoff
frequency of the left filter (Envelope Amount). In the center position, the
cutoff of the filter is not changed. As you turn it to the right, the filter
cutoff opens further, and the corresponding right LED lights up. If you turn
it to the left, the filter gets closed in the rhythm of the envelope signal, and
the left LED lights up.
The LEDs show the phase of the modulating signal. If LFO intensity and
Env Amount are set to high levels, both LEDs may light up alternating on
sine LFO. They light up in the rhythm of the phase of the modulation
signal.
Env Amt 2:
This operates exactly like Env Amt 1, but affects only the cutoff frequency
of the right filter.
Mix 2-1:
With this knob, you can mix the output signal of the right filter with
positive or negative phase into the left filter. At center position the
intensity is zero. Turning to the left increases the negative phase
9
Downloaded from www.Manualslib.com
E n v e lo p e
E n v e lo pe
manuals search engine
T-Rackonizer Operating Manual