Jomox T-RACKONIZER Bedienungsanleitung Seite 14

Cutoff CV:
Please keep in mind that the internal Cutoff knob is an amount to the
external CV once you have plugged in a CV cable.
If you turn up the Cutoff control knob fully clockwise, the CV range goes
from 0..5 V. However, if you only turn up the Cutoff knob halfway, you
would need a CV range of 0 to 10V to have the full range. Most CV
sequencer's CV ranges are limited to 5 Volts though.
Mix CV:
Please keep in mind that the internal Feedback knob is an amount to the
external CV once you have plugged in a CV cable.
As Mix is a dual polarity control, the internal CV needs to reach 2.5 Volts
for Mix center position (=zero). This can be achieved if you turn up the
internal control knob fully clockwise. With a CV range of 0..5 V you can
now go through every position of the Mix parameter – which is important
as the mix parameter can cause severe feedback and screaming sounds if
not smoothly adjusted.
However, if you only turn up the knob halfway to center position, you
would need to apply 5V to reach the center position and 10V to go across
into the positive area. As most CV sequencers only deliver 0 to 5 Volts you
need to open the Mix knob fully clockwise to have the full control range.
14 T-Rackonizer Operating Manual
Downloaded from www.Manualslib.com manuals search engine