Yard Force GDGS12 Original Bedienungsanleitung Seite 24

Only plunge saw soft work piece (wood, etc.).
Fig.12
Cutting with using the clamping jaw(Fig 13)
When cutting the branch, tube etc.
The spring-loaded clamping jaw will provide better control. The jaw can always catch the
work piece
firmly and keep the blade in the same position to perform the cutting work from the
beginning
to the end.
1.
2.
3.
Flush cut (Fig 14)
When using flexible saw blades with the Required length you can cut protruding pieces, e.g.
pipes, flush with the wall.
1.
2.
3.
Downloaded from www.Manualslib.com
CAUTION! RISK OF KICK-BACK!
Target line
Place the bottom edge of front
guard on the workpiece
Rest the clamping jaw on the work piece.
Switch on the device.
Apply even and slight downward force to finish your cutting work.
Fig.13
Place the saw blade directly against the protruding piece. With the front guard of saw
rest on the side wall.
Apply sideways pressure to the reciprocating saw.
Switch on the tool and saw through the work piece, applying consistent pressure.
manuals search engine
OPERATION
Tilt
Board
Cutting wood with the
use of clamping jaw
22
Hod it upright
Board