Yard Force GDGS12 Original Bedienungsanleitung Seite 19

Installing the clamping jaw (Fig 3)
1.
2.
If the blade was assembled in the tool, to remove the clamping saw, it's better to remove
the blade firstly.
Removing the clamping jaw (Fig.4)
To remove the clamping jaw, Depress the end of Unlock Button with one hand, then Pull
clamping jaw out along the slot of the front guard, after the clamping jaw leave out the
main housing completely, Release the Unlock Button and it will go back to its original
position.
Downloaded from www.Manualslib.com
Depress the end of unlock Button with one hand, Use the other hand to tilt the saw
head so that the shoe of front guard can enter into the opening of the clamping jaw,
at this moment keep two inserts of the clamping jaw line up with corresponding slots
on the front guard. Push it in, let it go as far as possible.
Release the Unlock Button to lock the clamping jaw. Check the clamping jaw be
locked tightly or not.
Fig.3
NOTE:
Fig.4
Remove
manuals search engine
ASSEMBLY
Depress
Insert
Clamping jaw has been assembled
Depress
Clamping clamp has been removed
17