Operation - Yard Force GDGS12 Original Bedienungsanleitung

Charging the battery Pack (Fig 7)
charger after it has been fully charged.
fully charged before first use.
charger.
1.
2.
battery
pack is too hot and cannot be charged.
Remove the battery and allow it to cool for 30 minutes and then re-insert it.
3.
4.
To obtain the best life from the battery
Never allow the battery to completely discharge before recharging. The battery pack
should be placed on the charger whenever the battery pack is noticeably running down or
the tool no longer performs a task it previously performed.
Downloaded from www.Manualslib.com
NOTE: The battery pack will be fully charged after 70mins. Remove it from the
NOTE: This battery pack has been shipped in a low charge condition. It should be
NOTE: Make sure the main voltage is the same as rating label which located on the
Connect the charger to a power supply. The green LED power light comes on,
indicating the charger is ready for use.
Align the raised ribs of the battery pack with the slot in the charger. Insert the battery
pack into the charger. The red LED light will come on, and the green LED light will
shut off at the same time, indicating the battery is correctly seated and on charge.
Fig.7
Charger
NOTE: If the red LED light doesn't comes on, and the green LED light is still on, the
The battery pack will normally be fully charged after 70 minutes, when the red LED
light will shut off and the green light comes on again. The initial charge may take
longer.
Remove the battery pack from the charger.
manuals search engine

OPERATION

Battery pack
19