Adjustment - Helios KWL-MZB-ZR Montage- Und Betriebsvorschrift

Installation and Operating Instructions
Central Controller KWL-MZB-ZR
EN
"Activate search" You can start the search for connected MultiZoneBoxes here.
You can follow the progress of the search in the left half of the screen by the increasing number of "Current addresses".
You can see how many MZB have already been found in the network under "Number of MZB".
You can enter at which number the search should begin under "Specify start address".
Save the information regarding which boxes are available via "Save changes". Please make sure to save or confirm with
"OK" after searching.
Connected boxes
"Connected boxes" See how many KWL-MZB are currently registered in your network here. Clicking on the button
will open a list of the addresses of connected MZB. You will gain remote access by clicking on the button for the box.
Delete list of connected MZB
"Delete list of connected MZB" You can delete the registered MZB again here.

Adjustment

The "Adjustment" button is intended for the adjustment of the overall system, you can activate the adjustment here. After
activation, you can select at which ventilation level each individual registered MZB is operated under "Adjustment spe-
cification ventilation level". Manual inputs on any control elements are disabled. Following adjustment, the "Adjustment"
function must be deactivated again. When adjustment is activated, "Adjustment active" will appear in the main menu
behind the Commissioning heading.
2 . Current values
Click on the "Current values" button. This will open the submenu (see Fig. 4).
Fig .4
Central control
"Central control" ï „Ventilation": You can display the cumulative values of volume flows, maximum shutter positions
and the current control voltages present at the 0-10 V output supply air/extract air fan (fan optimiser function) here (see
Fig. 5).
Fig .5
5