Helios KWL-MZB-ZR Montage- Und Betriebsvorschrift Seite 18

Installation and Operating Instructions
Central Controller KWL-MZB-ZR
EN
3 .2 .2 Access to KWL-MZB-ZR
Connect the MZB-ZR to your PC via a USB data cable.
Start the application "MultiZone configuration software",
Click on the "Establish connection via USB" button.
This will open the main menu of the software (see Fig. 1).
Fig .1
1 . Commissioning
Click on the "Commissioning" button.
This will open the commissioning menu.
(Upon first access, the "Connected boxes", "Delete list of connected MZB" and "Adjustment specification ventilation
level" buttons will be greyed out, see Fig. 2).
Fig .2
Auto search
Here you can search for new or connected MZB in the network.
For this purpose, click on the "Auto search" button and the following submenu will then open (see Fig. 3).
Fig .3
First, list all BUS addresses of the individual MZB throughout the property using the sample form in the ap-
+
TIP
pendix (see p .10) . Determine the lowest and highest BUS address in your table . Enter the lowest number as
the start address and deactivate the search once the highest number in the network is reached . All boxes are
now registered in the system . Do not forget to save before leaving the submenu .
4