Hama Color Edge 00186312 Bedienungsanleitung Seite 5

• Hang up the base/measuring station using the
opening (27) intended for this purpose.
6. Operation
6.1 Connection to the measuring station
• When the batteries have been inserted, the
base station automatically searches for a
connection to the measuring station and to
the radio signal.
Note
• The respective symbols will ash during
the connection attempts:
the measuring station,
the DCF signal
• Do not press any buttons during setup.
Otherwise, values may not be transmitted
correctly and there is a risk of value errors
and inaccuracies.
• Do not change the location of the base
station during the search processes.
• The process is completed when the indoor
(8) and outdoor (3) measurement data
is displayed.
6.2 Basic and manual settings
Automatic setting using the DCF signal
When the base station has been switched on
for the rst time and successful transmission
has been established between the base station
and the measuring station, the clock will
automatically search for the DCF signal. During
the search, the radio symbol
Display
Flashing display
Manual entry not
possible!
Constant display
No display
• If the station still does not receive a signal,
press and hold the UP button (19) for
approximately 3 seconds to start the manual
search for the DCF signal. The radio symbol
starts to ash.
Note – Time settings
• The search process can take up to 7
minutes. If it fails, the radio symbol
will go out.
• In the meantime, however, you can set the
time and the date manually.
4
connection to
connection to
ashes.
Search for the DCF
signal
Active
Successful –
signal is being received
Inactive
Note – Time settings
• The clock automatically continues to search
for the DCF signal on a daily basis (at 1
am and 5 am). If the signal is received
successfully, the manually set time and
date are overwritten.
Note – Summer time
The clock automatically switches to summer
time. appears on the display as long as
summer time is activated.
Manual settings
• Press and hold the SET button (20) for
approximately 3 seconds to make the
following settings one after the other:
• Time zone (from -12 to +12 hours CET)
• Hour
• Minute
• Year
• Month
• Day
• Unit of atmospheric pressure (hPa or inHg)
• Press the UP button (19) or DOWN button
(22) to select your setting. Press the SET
button (20) to con rm your entries.
Note – Time zone
• The DCF signal can be received over long
distances, but always transmits the current
Central European Time in Germany. Make
sure you account for the time difference in
countries in other time zones.
• If you are in Moscow, the time is 3 hours
later than in Germany. This means that you
should set +3 for the time zone. The clock
then sets the time automatically to 3 hours
ahead after receiving the DCF signal or
according to the manually set time.
Alarm
• Press and hold the ALARM button (23) for
approximately 3 seconds to set the time
of the alarm displayed. The hours display
begins to ash.
• Press the UP button (19) or DOWN button
(22) to select the hour for the alarm time
and con rm your selection by pressing the
ALARM button (23).
• Repeat the process to set the minutes for the
alarm time.
• Repeat the entire process to set the second
alarm.
• Press the ALARM button (23) once to display
the alarm time. Press the ALARM button (23)
once more to activate the alarm.
• Press the ALARM button (23) a third time to
deactivate the alarm.