Pipe Connections; Installation - Nibe SPS 10 Installateurhandbuch

Installation

General
NOTE
Pipe installation must be carried out in accord-
ance with current norms and directives.
NOTE
The water from the solar panel can reach high
temperatures. Hot fluid may therefore occur
during installation, commissioning or mainten-
ance.
If the expansion vessel is installed at the same height
■
or higher than NIBE SPS 10, install a heat reduction
loop/heat restriction.
Install the safety valve in such a way that it cannot be
■
shut off in any circumstances.
NIBE SPS 10 must not be exposed to overheating
■
through for example welding or soldering.
If required, flush all lines/pipes thoroughly before you
■
install the solar pump station. Dirt particles from
welding, hemp or any swarf can cause problems for
the flow meter, non-return valves and leakage in the
safety valve.
Mounting
Check that all sealing surfaces are clean and undam-
■
aged.
For more dimensions, see section Dimensions on page
18.
NIBE SPS 10 | GB

Pipe connections

Outline diagram
Connection to heat Connection to heat
exchanger, solar coil etc. exhanger, solar coil etc.
Explanation
GP30 Pump station NIBE SPS 10
EP30 SOLAR 40
BT53 Temperature sensor, solar panel
CM5 Expansion vessel
EP8 Solar panel
FL4 Safety valve, solar
GP4 Circulation pump, solar
RM3 Non-return valve
RM4 Non-return valve
QM43 Shut-off valve
QM44 Shut-off valve
QM45 Shut-off valve
1. Screw the solar circuit's pipes into the armature.
2. Connect pipes from the expansion vessel to the
safety group.
Connection kit SCS10 is available as an accessory,
consists of bracket/wall mounting, double action
non-return valve and flexible connecting pipe.
See section Accessories and spare parts on page 17.
-EP30-BT53
-EP8
-CM5
-GP30
T P
-RM4
T
-RM3 -FL4
-GP4
-QM44
-QM45
-QM43
13