Philips 3000 QT4015/15 Bedienungsanleitung Seite 8

English
8
4 Remove the cutting unit by pushing against the teeth of the cutting
unit and clean it with the brush or rinse it under the tap.
5 Shake off excess water and place the cutting unit back by inserting
the lug of the cutting unit into the guiding slot.
6 Push the cutting unit back onto the appliance ('click').
replacement
Only replace a worn or damaged cutting unit with an original Philips cutting
unit, available from authorised Philips service centres.
1 Open the cutting unit.
2 Remove the old cutting unit by pushing against the teeth of the
cutting unit.
3 Insert the lug of the new cutting unit into the guiding slot.
4 Push the cutting unit back onto the appliance ('click').