Cleaning And Disinfection; Ordering Accessories - Philips AVENT SCF330 Bedienungsanleitung

Cleaning and disinfection

Caution: Wash your hands thoroughly before you touch disinfected items and make sure the
surfaces on which you place disinfected items are clean.
Clean and disinfect all parts of the breast pump before first use. Clean all parts after each use and
disinfect all parts before each subsequent use.
1 Disassemble the breast pump completely. Also remove the white valve.
Caution: Be careful when you remove the white valve and when you clean it. If it gets damaged,
your breast pump does not function properly. To remove the white valve, gently pull at the
ribbed tab on the side of the valve.
2 Clean all parts in hot water with some mild washing-up liquid and then rinse them thoroughly.
You can also clean the parts in the dishwasher (on the top rack only). Do not put any other
objects on top of them.
Note: To clean the valve, rub it gently between your fingers in warm water with some washing-
up liquid. Do not insert objects into the valve, as this may cause damage.
3 Disinfect all parts in a Philips Avent steam steriliser or by boiling them for 5 minutes. For boiling,
fill a household pot with enough water to cover all parts. Bring the water to the boil. Place the
parts in the household pot and boil them for 5 minutes. During disinfection with boiling water,
prevent the bottle or other parts from touching the side of the pan. This can cause irreversible
product deformation or damage that Philips cannot be held liable for. Allow water to cool and
gently remove the parts from the water. Place the parts neatly on a clean paper towel or in a
clean drying rack and allow them to air-dry. Avoid using cloth towels to dry the parts because
they can carry germs and bacteria that are harmful to your baby.
Note: Do not use abrasive or antibacterial cleaning agents.
Note: Excessive concentration of detergents may eventually cause plastic components to crack.
Should this occur, replace immediately.
Note: Food colorings may discolor parts.
Note: Philips Avent storage cups and bottles are suitable for all methods of disinfection.
Storage
Keep the breast pump out of direct sunlight as prolonged exposure may cause discoloration.
Store the breast pump and its accessories in a safe and dry place.
Compatibility
The Philips Avent manual breast pump is compatible with Philips Avent bottles in our range and
Philips Avent storage cups. When you use other Philips Avent bottles, use the same type of teat
that was supplied with that bottle. For details on how to assemble the teat and general cleaning
instructions, see chapters 'Feeding your baby expressed breast milk' and 'Cleaning and disinfection'.
-
Spare teats are available separately. Make sure you use a teat with the correct flow rate when
you feed your baby.
-
Do not mix Philips Avent Anti-colic bottle parts and teats with parts of the Philips Avent Natural
bottles. They may not fit and could cause leakage or other issues.
-
The high-quality plastic Philips Avent Natural bottle is compatible with most Philips Avent breast
pumps, spouts, sealing discs and cup tops.

Ordering accessories

To buy accessories or spare parts, visit www.philips.com/parts-and-accessories or go to your
Philips dealer. You can also contact the Philips Consumer Care Center in your country.
English
11