Disposal Notes - Olympia CM 912 Bedienungsanleitung

Cutting power:
Shred size:
Shred speed:
Waste bin volume:
Noise level:
Security level:
Max. power consumption:
Size (W x H x D):
Weight:
Operating cycle paper/credit card:
Operating cycle CD:
Faults
Device does not
work
Device does not
work after lengthy
operation or stops
during operation
Jam
This symbol [the crossed-out wheeled bin/PICTURE] means that the
product should be brought to the return and or separate collection systems
available to end-users, when the product has reached the end of its life-
time. This symbol applies only to the countries within the EEA (*).
(*) EEA = European Economic Area, which comprises the EU Member
States plus Norway, Iceland, and Liechtenstein.
In the case of a defect, please return the device together with the receipt and original
packing material to the point-of-sale.
5 DIN A4 sheets (80 g/m²); 1 CD, 1 credit card
4 x 40 mm
2.0 m/min
11 l (0.8 l for CD bin)
approx. 72 dB
3
1.4 A
315 x 195 x 291 mm
3.1 kg
2 min. on, 60 min. off
2 min. on, 60 min. off
Device malfunctions
Cause
Is the mains cable plugged
properly in the socket?
Does the motor not start when
paper is inserted?
Was the device in constant
operation for some time?
Is the surface of the device
warm?
Have you inserted more than
5 sheets of paper (80 g/m²) or
more than 1 CD/credit card?
Has the material not been
inserted straight in the in-feed
slot?

Disposal Notes

Guarantee
13
Remedy
Plug the mains cable into the
socket properly.
Slide the paper in the respec-
tive slot so that it touches the
sensor in the centre.
Pull out the mains plug from
the socket and allow the motor
to cool down to room tempe-
rature.
Set the sliding switch to REV
to push back the paper. Switch
the device to AUTO again to
shred the paper remaining in
the cutting unit.