Electrolux EHG30215 Benutzerinformation Seite 17

• The power cable must be placed in such
a way that it does not touch any hot part.
• Connect the appliance to the mains with
a device that lets to disconnect the appli-
ance from the mains at all poles with a
contact opening width of minimum 3
mm, eg. automatic line protecting cut-
out, earth leakage trips or fuse.
• None of a parts of the connection cable
can not get a temperature 90 °C. The
blue neutral cable must be connected to
the terminal block label with "N". The
brown (or black) phase cable (fitted in the
terminal block contact marked with "L")
must always be connected to the live
phase.
Replacement of the connection cable
To replace the connection cable use only
H05V2V2-F T90 or equivalent type. Make
sure that the cable section is applicable to
the voltage and the working temperature.
The yellow/green earth wire must be ap-
proximately 2 cm longer than the brown (or
black) phase wire.
Assembly
min. 650 mm
If two or more 30 cm hobs are to be instal-
led side by side into the same cut out, an
assembly kit is available at our Service Cen-
tres. The kit contains a support side brack-
et, supplementary seals and the installation
instructions.
Put the seals supplied with the hob on the
edge of the cut out. Make sure that the
ends fit together without overlapping.
A) Supplied seal
B) Supplied brackets
Possibilities for insertion
Kitchen unit with door
The panel installed below the hob must be
easy to remove and let an easy access in
case a technical assistance intervention is
necessary.
490 mm
270 mm
a) Removable panel
b) Space for connections
Kitchen unit with oven
The hob recess dimensions must obey the
indication and the kitchen unit must be
equipped with vents to let a continuous
supply of air. The electrical connection of
the hob and the oven must be installed
separately for safety reasons and to let easy
remove oven from the unit.
B
30 mm
min 20 mm
a
(max 150 mm)
60 mm
b
electrolux 17
A