ATS1330 Power Distribution Board Installation
Sheet
EN DE
1
EN: Installation Sheet
Description
The power distribution board, model ATS1330, provides a
simple means of star connecting ATS bus devices. It is fitted
with a single protected input port and five paralleled output
ports, providing either the traditional power and comms or
power alone. It is a standard board size and provides a power
OK LED (Figure 2, item 8) for easy diagnosis.
The module has an incoming and outgoing data bus / power
connection to achieve i.e. a proper stub connection for an
Advisor Master bus reader.
Mounting location
The ATS1330 PCB (Figure 1) can be mounted in any Advisor
Master cabinet, which supports the size B board.
© 2012 UTC Fire & Security. All rights reserved
2
Connecting the ATS1330
Figure 2 legend
Item
Description
(1)
ATS control panel (Mains powered device)
(2)
TERM — termination link
(3)
GND — earthing link
(4)
Building earth
(5)
Remote arming station (RAS)
(6)
Shield connection between mains powered and non-mains
powered device(s)
(7)
4-door DGP (mains powered device)
(8)
Power OK LED
(9)
DGP (mains powered device i.e. ATS1201)
TERM link fitted on first and last devices on the LAN. In a "star"
wiring configuration the TERM link is only fitted on the devices
at the ends of the two longest LAN cable runs.
1 / 4
P/N 1077855 (ML) • REV A • ISS 17AUG12