GB
– Do not place the appliance below/near electrical socket and other electrical appliances.
– Make sure that no impurities get inside the appliance (e.g. dust clouds, hairs etc.). If
impurities are sucked and settle inside the appliance, clean it (see article V. MAINTENANCE).
– When handling the appliance, avoid causing any injury.
– Do not place any device with open flame in the air flow coming out from the appliance
because of danger of burning process interruption.
– Never expose yourself (or animals) to the air flow for an extended period of time.
It may cause health problems.
– Only use original components designed for this type.
– Holes for air ventilation must not be covered.
ADAPTER:
If the adaptor of the appliance is corrupted, it has to be replaced
–
by the manufacturer, its service technician or a similarly qualified
person so as to prevent dangerous situations.
– Use the charger in a room only.
– The adaptor supplied with this appliance is intended for this appliance only, do not use
it for other purposes.
– The power cord must not be damaged with sharp or hot objects, open fire, it must not be
sunk into water or bent over sharp edges.
II. DESCRIPTION OF THE APPLIANCE (Fig. 1)
A – Cooler body
A1 – ON/OFF button + blow speed setting button
A2 – LED decorative light setting button
A3 – LED indicating lamp of connected power supply
A4 – LED indicating lamps of speed
A5 – LED decorative light
A6 – frontal rotary grid
A7 – tilted holder
A8 – base with a water container
A9 – unit with textile plates
A10 – power supply connector
B – power adapter
III. PREPARATION FOR USE
Remove all the packing material and take out the appliance. Remove all possible adhesion
foils, stick–on labels or paper from the appliance. Place the appliance on a suitable flat
and dry surface. Leave free space for due ventilation. Vents in the appliance ensure air
circulation during ventilation and they must not be covered or blocked in another way. To
fill the container with water, extract the base A8 (Fig.1). Pour cold water into the container
(about 270 ml), to achieve the best cooling effect. When assembling, the arrow on the wall
of the base has to be directed toward the frontal side with the rotary grid.
If there is water in the container, be particular when mounting and demounting
the base A8 to prevent from leaking water into the appliance.
ATTENTION
18 / 39