Siemens TK 52-Serie Gebrauchsanleitung Seite 18

en
Adjusting the grinding unit
Sliding switch 15 adjusts the degree of
Warning
Adjust the grinding unit only while it is
running! Otherwise the appliance may be
damaged.
the sliding switch 15 to the desired posi-
grind.
i
The new setting will not become apparent
until the second or third cup is brewed.
Tip: For dark roast coffee beans, choose a
Float
19 in the water tray 18 shows
when the tray needs emptying.
19 is clearly visible, empty the
water tray 18.
Using coffee beans
This fully automatic espresso/coffee
machine grinds beans freshly for each
brew. If possible, use only beans for fully
automatic coffee and espresso machines.
Deep-freeze or store in a cool place in
sealed, airtight containers. Coffee beans
can be ground while frozen.
Important: Fill the water tank with fresh
water every day. The tank must always
appliance. Do not allow it to become empty.
Tip: Pre-warm cups, especially small, thick
espresso cups, by placing on the cup shelf
14 or rinsing with hot water.
The appliance must be ready for use.
coffee outlet 9.
14
coffee strength. The coffee is brewed and
dispensed into the cup(s).
the selected quantity has been dispensed
(factory setting approx. 125 ml).
i
The brewing process can be terminated
at any time by pressing the coffee
K
. dispensing button
Extra coffee
It is possible to dispense the same amount
of coffee a second time.
5 K
or
complete.
Note: The second cup is brewed using the
previously ground coffee.
Changing volume
dispensed
It is possible to change the factory setting
(approx. 125 ml) for the volume of mild or
strong coffee to be dispensed.
Important:
The appliance must be in operating mode.
This function is not available in "eco" mode.
button
coffee has been delivered (range approx.
30 – 220 ml).
i The volume can be changed again at
any time. To restore the factory setting of
approximately 125 ml, simply reset the
appliance.
5 K
or to select the desired
5 K
or .
within 3 seconds after brewing is
5 K
or until the desired volume of