Requirements For Installation Location; Temperature Sensor Installation - Panasonic PAW-BTANK50L-2 Installationsanleitung

3.4 Requirements for installation location and
positioning
The product shall be placed in a room with a drain to prevent any damages in case of
!
water escaping from the product..
!
The product shall be placed in a dry and permanently frost-free position.
The product shall be placed on a floor or wall suitable for the total weight of the product
!
when in operation. See table in page 5. Wall bracket is supplied.
The product must have a clearance for servicing of 40 cm in front of the unit / 10 cm over the
!
top connection.
!
The product shall be easily accessible for servicing and maintenance.
Min.
40 cm

3.4.1 Temperature sensor installation

The product is equipped with a temperature sensor
bracket which allows installation of a 6 or 8 mm.
temperature sensor. To install the temperature sensor
follow the instructions below.
1. Remove temperature sensor bracket (A) from
tank body by gripping it and pulling straight out.
2. Insert temperature sensor (B) firmly into the
appropriate grooves in the sensor bracket and
place the temperature sensor cable in the cable
slot (D).
An 8 mm. sensor (shown) fits in the upper
grooves (C) while a 6 mm. sensor fits in the lower
groove (E).
3. Refit the sensor bracket into the tank body,
ensuring the bracket is inserted fully to establish
proper contact between the sensor and the
stainless steel inner tank surface. Make sure the
sensor cable is positioned properly in the cable
slot (D) to avoid potential damage to the cable.
! CAUTION
Min.
45 cm
D
B
C
E
Min. 10 cm
Min. 40 cm
A
A
7