Care, Storage And Charging; Charging Batteries; Troubleshooting - Lupine PIKO Bedienungsanleitung

Productcare, Storage and Charging
Product Care and Storage
Light:
After use in dirty areas clean the lamp and the cables externally with warm water and some mild
detergent.
Important!
Because of the delicate sealings, we do not recommend to open the lamp.
A leakage in consequence of opening the light is excluded from warranty! Before you try to repair
something on your own get in touch with our helpful Service Team.
Battery:
If you intend not to use the lamp for a longer period of time, fully charge and store it at a cold and dry
place. When kept in a cool place, the annual self-discharging rate for such batteries is 15 %.

Charging Batteries

1. Plug the included Wiesel charger into an outlet.
2. Connect the charger to the battery, charging starts automatically the LED turns red.
3. The battery can be left plugged into the charger for an indefinite period. Although this will not damage
the battery, it is not advisable for Li-Ion batteries since they do not require conservation charging.
4. When the battery is fully charged the LED on Charger turns green.
 Warning! This charger is to be used to charge rechargeable Li-Ion batteries only.
It is NOT suitable for charging NiMH batteries!
 Do NOT use non-rechargeable batteries. – Risk of explosion!
 This charger may be opened ONLY by the manufacturer!
28 Piko
Downloaded from www.Manualslib.com manuals search engine
Problem Cause
The light does not come on Extremely discharged battery.

and the power LEDs do not
flash when the battery is
plugged into the lamp. Battery not plugged into the

light or not plugged in
properly.
With the battery plugged in, Faulty LED unit.

the power LEDs do not come
on, but the PCS LEDs flash.
The runtime is too short. Discharged battery.

Old battery.

Very low ambient

temperature.
Faulty charger.

Unsuitable battery.

Even after charging only The indicator was reseted

the 20% LED will light up
at the Smartcore battery.

Troubleshooting

Solution
Charge the battery.

Check all plug contacts.

LED unit needs replacement.

Get in touch with Lupine.

Charge battery.

Replace battery.

Keep battery warm.

Replace charger.

Use original Lupine battery.

Discharge the battery with

your light and fully charge it
afterwards.
Piko 29