Product Care And Storage; Troubleshooting - Lupine Betty R 7 Bedienungsanleitung

8

Product care and storage

Plug contacts:
Normally the plug contacts are maintenance free. However, if you use your Betty R light in humid,
salt- air, environments, it's advisable to apply a thin layer of
so often to prevent oxidation. Do NOT use terminal grease or contact spray.
Transport:
Important: Always keep the battery separate from the Betty R light,
amount of power used by the electronics will discharge the battery, and the lamp may switch on
accidently. Important! Moreover, the consequent uncontrolled heat buildup could cause a fire or
melt the adjacent plastic material. Could cause fire or
Storage:
During lengthy periods of non-use, fully charge the battery and store it in a cool, dry place, basement
or the like. The battery can be kept plugged into the charger if desired.
Opening the light housing:
Open the light housing's front screw-on cover. Grasp the rear section of the lamp with one hand while
rotating the front section of the cover to the left (counterclockwise) with the other hand. Once you
have removed the cover, you will see the 7-array lens. Do not touch it.
Closing the lamp housing:
Check to ensure that the O-ring on the rear section of the housing is correctly positioned.
The housing will only be waterproof if its O-ring is intact. After completing this inspection, carefully
screw down the housing cover. Important note: if the thread runs smooth, the cap is in the right
position. Otherwise please stop and screw back the cover and try again, otherwise you might
damage the thread.
Receiver:
The housing of the radio receiver on the underside of the lamp head may only
be opened by Lupine.
4 6 Betty R
Lupine Dutch Grease to the contacts every
because otherwise the small
death!
Problem Cause
 Extremely discharged battery.
The light does not come on
and the power LEDs do not
flash when the battery is
plugged into the lamp.
Battery not plugged into the

light or not plugged in properly.
With the battery plugged in,
 Faulty LED unit.
the power LEDs do not come
on, but the PCS LEDs flash.
Discharged battery.

The Power LEDs do not stay on for Old battery.

as long as they should. Very low ambient

 temperature.
 Faulty charger.
 Unsuitable battery.
 The battery's internal
Battery cannot be charged:
electronics blocked further
Charger does not respond when
discharge by shutting down.
a battery is connected to
It will take the connected
it and does not begin charging.
Charger a few minutes
to initialize and begin
charging.
The lamp does not recognize  Lamphead and transmitter are
the transmitter. not linked.
The transmitter does not light up
Button cell empty or wrong

while pressing the button and the
side up.
lamp does not react.

Troubleshooting

Solution
 Charge the battery. Before
doing so be SURE to read
the "Battery cannot be
charged" section below.
Check all plug contacts.

 Replace the LED unit.
Charge battery.

Replace battery.

Keep battery warm.

 Replace charger.
 Use original Lupine battery.
 Leave the battery connected
to the charger and wait.
This process can take up to
an hour.
 See chapter operation
remote control.
See chapter operation

remote control.
Betty R
9
47