Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation and operation manual
Content
1.
Introduction ................................................. 3
2.
Features of ELS 300 .................................... 3
3.
Applications ................................................. 3
4.
Dimensions .................................................. 4
5.
Installation ................................................... 4
5.1.
Connecting diagram ................................. 5
5.2.
Testing for Cat. 2 applications .................. 5
5.3.
5.4.
Timing diagram ......................................... 6
6.
Application with Y-switches ....................... 7
6.1.
Output current ........................................... 7
6.2.
7.
Accessories ................................................. 8
8.
Troubleshooting .......................................... 9
9.
Technical data ............................................. 9
10.
Ordering information ................................ 10
© CEDES/October 2016
Downloaded from
www.Manualslib.com
manuals search engine
1.
Introduction
The ELS 300, is a through-beam safety light barrier
and is certified as an active opto-electronic
protective device (AOPD) Type 2, according to
EN 61496-2:2013. It consists of an emitter (Tx) and
a receiver (Rx) which has a built-in controller with
PNP or NPN output, light or dark switching. A
"Snap-In" mechanism allows fast mounting in a
mounting hole with a diameter of just 12.5 mm. A
green LED on the rear side of the Tx indicates if the
power is on. A green LED on the Rx rear side
indicates the output status. The device is sealed and
completely protected against moisture and dust,
according
to
operation is not affected even by direct sunlight up
to 100,000 Lux.
2.
Features of ELS 300
Type 2 sensor suitable for Cat. 2 applications
•
Integrated controller
•
Standard, long-range and narrow versions
•
available
PNP or NPN output, light or dark switching
•
available
Very resistant to ambient light
•
For indoor or outdoor applications
•
Excellent detection capability even in harsh
•
conditions
Small and sleek design with plug-and-play
•
concept
Various mounting adapters available
•
Simple mounting: snap into a 12.5 mm
•
diameter drill-hole
Comprehensive range of cables
•
Multiple ELS 300 connectable to a network
•
using Y-switch
3.
Applications
The ELS 300 through beam sensor family consists
of different types of sensors for automatic sliding
doors,
elevator
entrance gates and similar applications. Please refer
to the relevant national standards for the specific
application.
The ELS 300 can also be used as a safety light
barrier in the machine industry. In such applications,
the combination of the ELS 300 with a supervising
control unit (e.g. a programmable logic control,
PLC), can reach safety category 2 Performance
Level 'c', according to EN ISO 13849-1:2015.
www.cedes.com
ELS 300
protection
class
IP65.
doors,
escalator,
travelators,
Reliable
3
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
