Tips For Saving Energy - Siemens KU..L Serie Gebrauchsanleitung

Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Take out glass shelves
Fig. $
Lift the glass shelves, pull forwards,
lower and swivel out to the side.
Taking out pull-out container
Fig. '
Lift the container and pull out.
Condensation channel
Fig. +
To clean the condensation channel, take
out the pull-out container. Fig. !/4
Regularly clean the condensation
channel and drainage hole with a cotton
bud or similar implement to ensure that
the condensation can drain.
Taking out vegetable container with
cover
Fig. (
Lift vegetable container and take out
forwards.
Take out shelves in the door
Fig. &
Lift shelves upwards and take out.
Taking out the bottle holder
Fig. )
Lift bottle holder at the rear and remove
from the door shelf.
Ventilation opening
Fig. ,
The ventilation grille in the base can be
removed for cleaning. To do this,
depress the clips in the ventilation
openings and simultaneously remove
the ventilation grille forwards.

Tips for saving energy

Install the appliance in a dry, well
■
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
Allow warm food and drinks to cool
■
down before placing in the appliance.
Thaw frozen food in the refrigerator
■
compartment and use the low
temperature of the frozen food to cool
refrigerated food.
Open the appliance as briefly as
■
possible.
Regularly defrost the freezer
■
compartment to remove the layer of
frost!
A layer of hoarfrost will impair
refrigeration of the frozen food
and increase power consumption.
Ensure that the freezer compartment
■
door has been closed properly.
The arrangement of the fittings does
■
not affect the energy rating of the
appliance.
en
33