SATA J Serie Bedienungsanleitung Seite 14

10） Be sure to pull the plug off before removing the battery pack.
11） During the charging, it is normal for the charger and battery pack to heat up.
12) When the machine is not in use, do not insert the charged battery pack into the charger.
13) After the charging is over, please pull the battery pack off the charger immediately.
14) During the operation, it is normal for the body and battery pack to heat up.
15) Do not put the discarded battery pack in fire or dispose it with domestic garbage, and be sure to send it to the local collection
station or recycling point.
16) Carefully check for the cable, natural gas or water pipes before driving the screw or drilling the hole in the wall, floor and ceiling.
17) Wear the earmuffs when operating the machine. Otherwise the hearing may be damaged.
18) During the operation, it is normal for the accessories and metal parts to heat up.
19) The operating machine may come into contact with the hidden wires. Therefore, be sure to hold the insulating surface of machine.
Contact with the live wires may electrify the metal on the surface of machine and cause an electric shock of user.
Warning
Battery pack leakage may occur if the operating temperature is too high or the pack is excessively used. If the liquid
leaking from the battery gets on the skin, wash it with soap first, then rinse it with lemon juice or vinegar. In case of
contact with the eyes, rinse the eyes with clean water immediately and go to the hospital for treatment.
Safety warning of charger:
1. Please read the instruction before use.
2. Only for indoors, no rain or water
3. Do not charge the non-rechargeable battery.
4. The damaged power cord shall be replaced by the professional technician from the manufacturer, its service department or similar
department.
Safety warning of rechargeable impact screwdriver
1. The fasteners may come into contact with the hidden wires. Therefore, be sure to hold the insulating surface of machine. Contact
with the live wires may electrify the metal on the surface of machine and cause an electric shock of user.
2. Be sure to stand firmly. Make sure that no one is underneath when using the tool at height
3. Please hold this tool firmly
4. Wear earmuffs.
5. Do not touch the screwdriver bit or workpiece immediately after operation. They can be very hot and cause burns to the skin.
6. Keep hands away from rotating parts.
14
51086
中文
EN DE RU KO PT JA ES