TrekStor DataStation maxi z.ul Handbuch Seite 44

EN
Downloaded from www.Manualslib.com
"Stripe" (RaID0)
In the "s " coupling mode, you can combine 2 (4 or 8)
triPe
maxi z.ul
units. The data is written to both hard disks at the same time,
which can be an advantage as far as speed is concerned.
Note: It is recommended to use only
of the same size in this mode. If you use hard disks of different sizes, you only have
twice (four times or eight times) the total size of the smallest
maxi z.ul available in the Stripe system. This is a specified characteristic of
the Stripe system, so as to ensure continuous parallel writing.
Example: 1x DataStation maxi z.ul 160 GB + 1x DataStation maxi z.ul 250 GB
= 1x DataStation maxi z.ul 320 GB in the Stripe mode)
Note: The danger of losing data increases in the Aggregation and Stripe
modes, since it is not possible to read the data if one of the two hard disks is no
longer functioning.
"Mirroring" (RaID1)
The "m " coupling mode enables real-time mirroring of the
irroring
DataStation maxi z.ul
data from a primary
DataStation maxi z.ul
DataStation maxi z.ul
of the primary
DataStation maxi z.ul
a continuously up-to-date backup.
DataStation maxi z.ul
Note: When mirroring 2
memory of the primary and / or the smaller
at your disposal. This is required in a mirroring system, since the secondary
DataStation maxi z.ul
DataStation maxi z.ul
of the primary
Example: 1x DataStation maxi z.ul 160 GB + 1x DataStation maxi z.ul 250 GB
= 1x DataStation 160 GB in the mirroring system)
manuals search engine
DataStation
DataStation maxi z.ul
DataStation
to a secondary
. The data is written as continuous copies
onto the secondary
, if changes or edits are made – much like
, you have the
DataStation maxi z.ul
is available solely for backing up the data
.
– 44 –
units