Before Starting; Charging Procedure - Avdel TX2000 Betriebsanleitung

Before Starting

Before starting, please read and follow the operating instructions carefully.
C H A R G I N G P R O C E D U R E
•
The charger must only be used with Avdel
•
Take the charger out of the case and connect to the mains power supply. The solid
red LED indicates that the charger is operational.
•
Insert the battery correctly into the charger with minimal force.
•
If the green LED flashes when the battery is inserted this indicates that the battery is
too hot. Remove the battery and allow to cool before trying again.
•
The battery charging process is indicated by a solid green LED.
•
Re-charging takes up to 40 minutes, depending upon the level of charge remaining
within the battery.
•
The end of the charging process is indicated by the flashing green LED.
C H A R G I N G P R O C E D U R E
•
•
•
•
•
•
•
•
•
•
8
Downloaded from www.Manualslib.com
A P - H B W / t u 1 2 0 3
A P / U L E - 1 2 0 1 & A P / U L U J - 1 2 0 1
The charger must only be used with Avdel
Take the charger out of the storage case and connect to the mains power supply. The
Left LED will be SOLID RED. The Right LED will be SOLID GREEN for 2 seconds - in
this time a self-test will be performed - indicating that the charger is operational.
If the LH LED FLASHES RED this indicates that the charger is not functioning correctly
- charging is not possible. If this occurs please contact an authorised Avdel
representative.
Insert the battery correctly into the charger with minimal force.
The battery charging process is indicated by the SOLID GREEN RH LED.
If the RH LED FLASHES RED when the battery is inserted this indicates that the
battery is too hot. Remove the battery from the charger and allow it to cool before
trying again. This will occur when the battery temperature is above 65°C and can
result if the battery is inserted directly after charging or discharging.
If the RH LED shows SOLID RED this indicates that the battery is faulty. Remove
battery from the charger and do not use.
A SOLID YELLOW RH LED indicates that the battery is at least 90% charged.
Removing the battery at this point will increase the service life of the battery. No
significant reduction in the performance of the battery will result.
A FLASHING GREEN RH LED indicates that the charging process is complete. The
battery will now be at 100% capacity. At this point the battery will be trickle charged
until removed. Overcharging of the battery will not occur.
When charging a Ni-MH battery the RH LED can be seen to FLASH RED & GREEN.
This also indicates that the charging process is complete.
manuals search engine
batteries.
®
batteries.
®
®