Operating Procedure - Avdel TX2000 Betriebsanleitung

Operating Procedure

O P E R A T I N G P R O C E D U R E
•
Connect the charged battery to the tool.
•
Insert the fastener stem into the nose of the tool. If using a standard nose tip the fastener must be held manually until
placed into the application.
•
Bring the tool with the fastener to the application so that the protruding fastener enters the hole of the application squarely.
•
Fully actuate the trigger. The tool will cycle and place the fastener. Release the trigger only when the fastener stem has
broken, the piston will then return to the forward position.
•
After each cycle, the spent fastener stem must be disposed of by tilting the tool nose up, allowing the stem to fall back
into the collection container at the rear of the tool.
•
If the trigger is not released the tool will stop after approximately 4 seconds of operation, preventing overload. Releasing
the trigger will reset the control circuit allowing the tool to operate as before.
•
Empty the collection container when more than half full of stems.
•
To empty the collection container tilt the tool nose down and lift the collector lid.
•
Please read daily servicing details on page 13.
To achieve the optimum performance from the tool, please adhere to the following guidelines when operating:
•
Fully depress the trigger when placing fasteners to achieve the optimum cycle rate, pull-force and efficiency.
•
Release the trigger immediately after the rivet stem has broken in order to gain the maximum number of cycles from the
battery.
•
Do not operate the tool to the point of pressure relief and motor cut-out. These features are only to protect the tool from
operator overload and abuse. Continual operation in this way will rapidly drain the battery.
Downloaded from www.Manualslib.com manuals search engine
English
11