Hinge Profile - EINHELL FBS 62A Aufbauanleitung

Anleitung FBS 62 A 25.11.2004
Please follow the order described for assembling the profiles.
Check the profiles against item numbers in the replacement part list and also according to their lengths. If not
stated otherwise, the item numbers given in brackets refer to the exploded diagram in Fig. 2.
To ensure simple assembly, proceed as follows:
General note: When mounting the profiles, make sure not to damage the edges of the plastic web panels.
1. Assembling sides halves (11 + 12)
1.1 Push the U-shaped longitudinal profile (1) centrally onto the underside of front section (11) and rear
section (12) and the top of front section (11).
1.2 Mount the front section (11) with the H-shaped side connector (3) 8mm from the bottom edge. If you
have difficulties mounting the H-profile, the two outer webs of the front and rear section (11 + 12) can
be carefully compressed with a block of wood and a hammer.
1.3 Connect the front section (11) and rear section (12) with the U-shaped side profiles (2) and (9).
1.4 Push the hinge profile (8) centrally onto the top of the rear section.
1.5 Push the four lower corners of the assembled side section (11+12) into the assembly corners (21).
2. Assembling hood half 1 (10a)
2.1 Mount the hinge profile 1 (6) on a long side of the hood half 1 (10a).
2.2 Press the side U-shaped hood profile onto the short side of the hood half 1 (10a) so that it adjoins the

hinge profile 1 (6).

2.3 Press the front hood profile 908 mm (4) centrally onto the second long side of the hood half 1 (10a).
3. Assembling hood half 2 (10b)
3.1 Press the hinge profile 1 (6) centrally onto one of the long sides of hood half 2 (10b).
3.2 Press the side U-shaped hood profile 2 (7)) onto the short side of hood half 2 (10b) so that it adjoins
the hinge profile 1 (6).
3.3 Press the hinge profile 2 (8) centrally onto the second long side of hood half 2 (10b).
4. Connecting hood half 1 (10a) to hood half 2 (10b)
Insert one hinge clamp (20) into hinge profile 1 (6) of both hood half 1 (10a) and hood half 2 (10b) on the left
and right side.
5. Connecting the completed hood with the completed side section
Insert one hinge clamp (20) into hinge profile 2 (8) of both hood half 2 (10b) and side half 2 (12) on the left and
right side.
6. Securing the hood corners (22) to the hood
Push the hood corners (22) onto both corners of hood half 1 (10a) and, working from below, tighten the screws
(25) through the hood corners and into the plastic web panels.
The screw is used to fasten the hood corner. Position the screws as illustrated.
All dimensions are 20
approximate.
10
7. Securing the clips (24) and setting the opening
Push the clips (24) onto the side halves. Three openings can be set. Preferably, one completely opened, one
completely closed and one individually adjustable opening. The cover corners (22) are pushed simultaneously
into the clips (24).
9:13 Uhr Seite 7
GB
7