Operating The Recorder - Interlogix TruVision DVR 45HD Schnellstartanleitung

By default, the setup wizard will start once the
recorder has loaded. The wizard walks you
through some of the more important settings
of your recorder. Select the preferred
language for the system and then set the
administrator password. There is no default
password provided.
The wizard will then guide you through the
menus to set the time and date, network
configuration, HDD management, and
recording configuration.
When all the required changes have been
entered, click
recorder is now ready to use. Recording
starts automatically.

Operating the recorder

There are several ways to control the unit:
• Front panel control
• IR remote control
• Mouse control
• Web browser control
• TVK-800 keypad
• Software (TruVision Navigator,
TVRmobile)
Front panel
The buttons on the front panel control most
functions. See Figure 2 on page 2 for the
locations of the controls.
IR remote control
The IR remote control buttons are similar to
those on the front panel. Place the two AAA
batteries in the remote control.
To connect the remote control to the
recorder:
1. Press
click the mouse and select Menu. The
main menu screen appears.
2. Select
Monitor.
3. Check the recorder's device address
value. The default value is 255. The
device address is valid for all IR controls.
TruVision DVR 45HD Quick Start Guide
Downloaded from www.Manualslib.com
Finish to exit the wizard. The
Menu on the front panel or right-
Display Mode Settings
manuals search engine
4. On the remote control press the
button.
5. Enter the device address value. It must
be the same as that on the recorder.
6. Press
USB mouse
The USB mouse provided with the recorder
operates all the functions of the recorder,
unlike the front panel, which has limited
functionality. The mouse lets you navigate
and make changes to settings in the user
interface.
Connect the mouse to the recorder by
plugging the mouse USB connector into the
USB port on the back or front panel. The
mouse is immediately operational and the
pointer should appear.
Web browser control
The recorder's Web browser lets you view,
record, and play back videos as well as
manage all aspects of the recorder from any
PC with Internet access. The browser's easy-
to-use controls give you quick access to all
recorder functions.
To access the unit, open a web browser and
enter the IP address assigned to the recorder
as a web address. In the logon screen, enter
the user ID and password.
The default values for recorder network
settings are:
• DHCP: Disabled by default.
• IP address: 192.168.1.82
• Subnet mask: 255.255.255.0
• Gateway address: 192.168.1.1
• Server Port: 8000
• HTTP Port: 80
• RTSP port: 554
Note: The following ports need to be
forwarded in the router in order to connect
properly: Server port and RTSP port.
>
OK
on the remote control.
Device
5 EN