Mounting And Removing Flat Panel Display - peerless-AV SP735P Montageanleitung

Mounting and Removing Flat Panel Display

• Always use an assistant or mechanical lifting equipment to safely lift and position the fl at panel displays.
Hook adapter brackets (B) onto adapter plate (A).
3
Turn security screws, using phillips screwdriver,
clockwise at least six times to prevent display from
being removed as shown in cross section of fi g.
3.1.
NOTE: To lock the display down, tighten safety/
security screws to wall plate as shown in cross
section.
To remove display from mount, loosen safety/
security screws, swing display away from mount,
and lift display off of mount.
CAUTION
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
If more or less tension is desired in tilt mechanism,
4
remove snap caps as shown in detail 1. Insert
a fl at head screwdriver into slot and pry cap
away from tilt mechanism. To adjust tilt, tighten
or loosen socket screw no more than half a turn
using 5 mm allen wrench (M).
To adjust roll (5° left or right), tighten or loosen
10-32 x 1/2" phillips screw.
• If screws become loose over time, tighten screws
as necessary. Tighten screws to 50 in • lbs
(5.6 N.M.) maximum torque.
Downloaded from www.Manualslib.com
WARNING
manuals search engine
WARNING
B
CROSS SECTION
SOCKET
SCREW
SNAP
CAP
8 of 42
A
SECURITY
SCREWS
10-32 X 1/2"
SCREW
SLOT
DETAIL 1
ISSUED: 02-15-10 SHEET #: 095-9316-2 08-02-11
B
A
fi g 3.1