Mounting And Removing Flat Panel Display - peerless-AV Paramount PA735F series Anbringung Und Zusammenbau

Mounting and Removing Flat Panel Display

• Always use an assistant or mechanical lifting equipment to safely lift and position the fl at panel displays.
Hook adapter brackets (B) onto adapter plate (A).
3
Turn security screws, using phillips screwdriver,
clockwise at least six times to prevent display from
being removed as shown in cross section of fi g.
3.1.
NOTE: To lock the display down, tighten safety/
security screws to wall plate as shown in cross
section.
To remove display from mount, loosen safety/
security screws, swing display away from mount,
and lift display off of mount.
CAUTION
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
10-32 x 1/2" screws are pretensioned and require
4
no adjustment. Rotate display by hand to level
display. Roll bracket allows 2° roll adjustment.
WARNING
• If screws become loose over time, tighten screws as
necessary. Tighten screws to 50 in • lbs
(5.6 N.m.) maximum torque.
WARNING
B
CROSS SECTION
8 of 38
A
SECURITY
SCREWS
1/4-20 X 1/2" SCREWS
ROLL BRACKET
ISSUED: 02-15-10 SHEET #: 095-9317-3 07-26-11
B
A
fi g 3.1