Installing Adapter Brackets - peerless-AV SP735P Montageanleitung

Installing Adapter Brackets

• Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening can
cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to display or product may fail.
To prevent scratching the display, set a cloth on a fl at, level surface that will support the weight of the display.
2
Place display face side down. If display has knobs on the back, remove them to allow the adapter brackets to
be attached. Place adapter brackets (B) on back of display, align to holes, and center on back of display as
shown below. Attach the adapter brackets to the back of the display using the appropriate combination of screws,
washers, and spacers as shown in steps 2-1 or 2-2.
For cable management option, install cable clip (O) in between display and adapter brackets (B).
NOTE: Top and bottom holes must always be used.
Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.
NOTE: For fl at back displays proceed to step 2-1. For bump-out or recessed back display skip to step 2-2.
Downloaded from www.Manualslib.com
B
O
CENTER BRACKETS
ON BACK OF DISPLAY
NOTE: "X" dimensions should be equal.
manuals search engine
WARNING
VERTICALLY
6 of 42
X
X
ISSUED: 02-15-10 SHEET #: 095-9316-2 08-02-11