peerless-AV SP735P Montageanleitung Seite 7

For Flat Back Display
Begin with the shortest length screw, hand thread through washer and adapter bracket into display as shown
2-1
below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not over
tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.
For Bump-out or Recessed Back Display
Begin with longer length screw, hand thread through washer, adapter bracket and spacer in that order into display
2-2
as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
Downloaded from www.Manualslib.com
DISPLAY
If you have any questions, please call Peerless customer care at 1-800-865-2112.
DISPLAY
SPACER
If you have any questions, please call Peerless customer care at 1-800-865-2112.
manuals search engine
WASHER
SCREW
ADAPTER BRACKET (B)
WASHER
ADAPTER BRACKET (B)
7 of 42
SCREW
ISSUED: 02-15-10 SHEET #: 095-9316-2 08-02-11