Installation To Wood Stud Wall - peerless-AV SP735P Montageanleitung

Installation to Wood Stud Wall

• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that wall plate is fi rmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud fi nder is
highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs.
Installers are responsible to provide hardware for other types of mounting situations (not evaluated by UL).
Use a stud fi nder to locate the edges of the studs. Based on their edges, draw a vertical line down each stud's
1
center. Place wall plate (A) on wall as a template. The top mounting slots should be located 3.4" (86 mm)
above the desired display center as shown in fi gure 1.1. Level adapter plate (A), and mark the center of the two
mounting holes. Make sure that the mounting holes are on the stud centerlines. Drill two 5/32" (4 mm) dia. holes
2.5" (64 mm) deep. Make sure that the adapter plate is level, and secure it using four #14 x 2.5" wood screws (C)
as shown in fi g. 1.2.
Insert two screw covers (L) into screw heads.
STUD
A
DC = DISPLAY CENTER
Downloaded from www.Manualslib.com
3.4"
(86 mm)
DC
fi g. 1.1
ADAPTER PLATE (A)
manuals search engine
WARNING
WALL PLATE (A)
C
L
4 of 42
fi g. 1.2
ISSUED: 02-15-10 SHEET #: 095-9316-2 08-02-11