Infrared Remote Control - Cameo LED Multi PAR Bedienungsanleitung

INFRARED REMOtE COntROl:

Set the multi-PAR lighting system to IR ACTIVE "ON" mode as described in the section "IR ACTIVE".
Functions of the control buttons on the IR remote control:
Bl (Blackout)
If you press this button when the lighting system is in operation, then all lights and both power outlets Light 1
and Light 2 will switch off. When the BL button is pressed again, the lighting system will return to the previously
selected mode.
SP (Speed)
4-stage speed setting for programmes Pr1 - Pr4 and D1 - D4.
Stage 1 makes the colour change sequence run slowly. Pressing again activates Stage 2 with a faster colour
change sequence, followed by Stages 3 and 4, whereby Stage 4 equals the fastest succession of the colour
change sequence.
(Brightness)
4-stage brightness setting for all programmes and static colour mixing. The various stages of brightness can be
activated by pressing this button repeatedly.
Fl (Flash / stroboscope)
4-stage speed setting for the stroboscope effect. Stage 1 deactivates the stroboscope effect, Stage 2 represents
low, Stage 3 medium, and Stage 4 the fastest flash rate. The stroboscope effect can be combined with the RGBW
colour mixing mode and all colour change programmes. The power outlet sockets in the multi-PAR system
remain unaffected by the stroboscope effect.
R / g / B / W (Red, green, Blue, White)
These 4 buttons can be used to create individual colour mixtures. The 4 levels of brightness can be activated by
repeated pressing of the respective colour button, whereby at Level 1 the LEDs are switched off.
For example: If you set red and green to the respective highest level and blue and white to the lowest, i.e., off,
the result will be a bright yellow colour mixture.
Pr1 - Pr4
Colour change programmes with various colour patterns. The programme jumps from one colour to the next. The
speed at which the colour change can be set using the "SP" (Speed) button.
D1 - D4
Colour change programmes with various colour patterns. The programme crossfades from one colour to the next.
The speed at which the colour change can be set using the "SP" (Speed) button.
SA1 - SA4
Music controlled colour change programmes with various colour patterns. The microphone for control is in the
multi-PAR lighting system.
light 1 / light 2 - On / OFF
Using these buttons, the 2 power outlets in the multi-PAR lighting system can be switched on and off separately
by remote control.
24