Electrical Connection - K&H 5Z-KHG Gebrauchsanleitung

Electrical Connection

The cooktops fitted with a tripolar electrical supply cord are designed to be be used with
alternating current according to the indications on the rating plate located under the cooktop. The
earthing wire can be identified by its yellow-green colour. In the case of installation over a built-in
electric oven, the electrical connections for the cooktop and oven should be independent, not only
for safety purposes, but also to facilitate removal of one or both in the future.
Electrical Connection for Gas Cooktop
Fit the supply cord with a standard plug for the demand rate indicated on the rating plate or
connect it directly to the electrical mains. In the latter case, a single pole switch must be placed
between the appliance and the mains, with a minimum opening between the contacts of 3 mm in
compliance with current safety codes (the earthing wire must not be interrupted by the switch).
The power supply cord must be positioned so that it does not reach a temperature in excess of
50~C above room temperature at any point.
Before actual connection make sure that:
 The fuse and electrical system can withstand the load required by the appliance;
 That the electrical supply system is equipped with an efficient earth hook-up according to
the norms and regulations prescribed by law;
 That the plug or switch are easily accessible.
Important: the wires in the mains lead are coloured in accordance with the following code:
Green & Yellow - Earth
Blue - Neutral
Brown - Live
Model
5Z-KHG
5Z-KHSSW
4Z-KHG
4Z-KHSSW
3Z-KHGW-3
2Z-KHG
2Z-KHSS
2Z-KHGW
2Z-KHGX-LPG
1Z-KHGW
Built-in size
560x480mm
270x480mm
29