Technical Specifications - Johnson Controls M9102 GA-1S Serie Installationsanleitung

Technical Specifications

M910x-xGA-1S
Product Codes M9102-AGA-1S
Power Requirements
Control Type
Input Signal
Feedback Signal
Motor Input Impedance
Running Torque
Travel Time
30 Seconds at 60 Hz
(for 90° of Rotation) 36 Seconds at 50 Hz
Rotation Range
91° ±2°, CW or CCW
100,000 Full Stroke Cycles;
Cycles
2,500,000 Repositions at Rated Running Torque
Audible Noise Rating
35 dBA Nominal at 1 m
Electrical Connections
1.2 m Polyvinyl Chloride (PVC) cable with 0.75 mm
Mechanical Connections
Up to13 mm Diameter Round Damper Shafts, or 10 mm Square Damper Shafts
Enclosure
NEMA 2, IP 42
Ambient Conditions
- Operating
-20 to 60° C; 90% RH Maximum, Noncondensing
- Storage
-29 to 66° C; 90% RH Maximum, Noncondensing
Shipping Weight
0.5 Kg
Compliance
- North America
UL Listed, File E27734, CCN XAPX (United States) and XAPX7 (Canada) - Actuator Housing is Plenum Rated per CSA C22.2 No. 236/UL 1995, Heating and Cooling Equipment
- European Union CE Mark, EMC Directive 89/336/EEC
- Australia and New Zealand C-Tick Mark, Australia / NZ Emissions Compliant
M910x-xGA-5S
Product Codes M9102-AGA-5S
Power Requirements
Control Type
Input Signal
Feedback Signal
Motor Input Impedance
Running Torque
Travel Time
30 Seconds at 60 Hz
(for 90° of Rotation) 36 Seconds at 50 Hz
Rotation Range
91° ±2°, CW or CCW
100,000 Full Stroke Cycles;
Cycles
2,500,000 Repositions at Rated Running Torque
Audible Noise Rating
35 dBA Nominal at 1 m
Electrical Connections
M3 Screw Terminals
Mechanical Connections
Up to13 mm Diameter Round Damper Shafts, or 10 mm Square Damper Shafts
Enclosure
NEMA 1, IP 40
Ambient Conditions
- Operating
-20 to 60° C; 90% RH Maximum, Noncondensing
- Storage
-29 to 66° C; 90% RH Maximum, Noncondensing
Shipping Weight
0.5 Kg
Compliance
- North America
UL Listed, File E27734, CCN XAPX (United States) and XAPX7 (Canada) - Actuator Housing is Plenum Rated per CSA C22.2 No. 236/UL 1995, Heating and Cooling Equipment
- European Union CE Mark, EMC Directive 89/336/EEC
- Australia and New Zealand C-Tick Mark, Australia / NZ Emissions Compliant
The performance specifications are nominal and conform to acceptable industry standards. For application at conditions beyond these specifications, consult the local Johnson Controls office. Johnson Controls, Inc. shall not be liable for damages resulting
from misapplication or misuse of its products.
2 M9102-xGA-xS / M9104-xGA-xS
M9104-AGA-1S
2.1 VA
Floating Control without Timeout
AC 24 V +25% / -20% at 50/60 Hz, SELV Class III
---
---
2 Nm 4 Nm
60 Seconds at 60 Hz
72 Seconds at 50 Hz
conductors and 6 mm ferrule ends
2
M9104-AGA-5S
2.1 VA
Floating Control without Timeout
AC 24 V +25% / -20% at 50/60 Hz, SELV Class III
---
---
2 Nm 4 Nm
60 Seconds at 60 Hz
72 Seconds at 50 Hz
M9102-IGA-1S
AC 24 V +25% / -20% at 50/60 Hz
2.5 VA
Safety Extra-Low Voltage (SELV) Class III
ON/OFF and Floating Control With Timeout
with Timeout
---
200 ohms Nominal
2 Nm
30 Seconds at 60 Hz
36 Seconds at 50 Hz
M9102-IGA-5S
AC 24 V +25% / -20% at 50/60 Hz
2.5 VA
Safety Extra-Low Voltage (SELV) Class III
ON/OFF and Floating Control With Timeout
with Timeout
---
200 ohms Nominal
2 Nm
30 Seconds at 60 Hz
36 Seconds at 50 Hz
M9104-IGA-1S M9104-GGA-1S
3.0 VA 3.6 VA
Modulating
DC 0(2) to 10 V or 0(4) to 20 mA
with field furnished 500 ohm resistor
DC 0(2)...10 V Corresponds to input
span selection (DC 10V at 1 mA)
4 Nm 4 Nm
60 Seconds at 60 Hz 60 Seconds at 60 Hz
72 Seconds at 50 Hz 72 Seconds at 50 Hz
M9104-IGA-5S M9104-GGA-5S
3.0 VA 3.6 VA
Modulating
DC 0(2) to 10 V or 0(4) to 20 mA
with field furnished 500 ohm resistor
---
4 Nm 4 Nm
60 Seconds at 60 Hz 60 Seconds at 60 Hz
72 Seconds at 50 Hz 72 Seconds at 50 Hz