Replacing The Nanoprotect Filter (Fig. ‹); Replacing The Nanocloud Rotary Humidification Wick - Philips AC2729 Benutzerhandbuch

Replacing the
NanoProtect filter
(fig. ‹)
Note
• The filter is not washable or
reusable.
• Always turn off the air purifier and
unplug from the electrical outlet
before replacing the filters.
Filter alert light
status
A3 is displayed
and the filter
replacement light
flashes on the
screen.
C7 is displayed
and the filter
replacement light
flashes on the
screen.
1
Remove the used filters from the
appliance (fig. Œ).
Note
• Do not touch the pleated filter
surface, or smell the filters as they
have collected pollutants from the
air.
• Wash your hands after disposing of
the used filters.
2
Remove all packaging material of
the new filters (fig. f).
3
Place the new filters into the
appliance (fig. g).
4
Touch and hold
reset the NanoProtect filter lifetime
counter.
EN
16
Follow this
Replace the
NanoProtect
filter Series 3
(FY1410)
Replace the
NanoProtect
filter Active
Carbon (FY1413)
for 3 seconds to
Replacing the
NanoCloud rotary
humidification wick
Filter alert light status Follow this
F1 is displayed and
the filter replacement
light flashes on
the screen (fig. ).
1
Take the wick wheel off the wick
support (fig. †).
2
Grip the shaft screw on the
other side of the wheel, rotate it
anticlockwise to release the wick
from the wheel (fig. Ž).
3
Unfasten the locks on the edge
of the wheel successively to
disassemble the wick wheel (fig. ).
4
Take the used NanoCloud rotary
humidification wick out (fig. ).
5
Remove all packaging material
of the new NanoCloud rotary
humidification wick (fig. l).
6
Place the new NanoCloud rotary
humidification wick in the wick
wheel, and then fasten the locks on
the wick wheel (fig. ').
7
Place the wick wheel on the wick
support (fig. m).
Note
• When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
8
Place the water tray and water tank
back into the appliance (fig. n).
9
Touch and hold
to reset the NanoCloud rotary
humidification wick lifetime counter.
Replace the
NanoCloud
rotary
humidification
wick
for 3 seconds