Cleaning The Body Of The Appliance; Cleaning The Air Quality Sensor; Cleaning The Water Tank, Water Tray And Nanocloud Rotary Humidification Wick - Philips AC2729 Benutzerhandbuch

Cleaning the body of the
appliance
Regularly clean the inside and outside
of the appliance to prevent dust from
collecting.
1
Wipe away dust with a soft dry cloth
from the body of the appliance.
2
Clean the air outlet with a soft dry
cloth.
Cleaning the air quality
sensor
Clean the air quality sensor every
2 months for optimal functioning of the
purifier. Clean them more frequently
if you use the purifier in a dusty
environment.
Note
• When the humidity level in the
room is very high, it is possible that
condensation develops on the air
quality sensor. As a result, the air
quality light may indicate that the
air quality is bad even though it is
good. In this case you have to clean
the air quality sensor or use one of
the manual speed settings.
1
Clean the air quality sensor inlet
and outlet with a soft brush (fig. ‚).
2
Open the air quality sensor cover
(fig. ƒ).
3
Clean the air quality sensor, the
dust inlet and the dust outlet with a
lightly moistened cotton swab
(fig. „).
4
Dry them with a dry cotton swab.
5
Reattach the air quality sensor
cover (fig. ...).
Cleaning the water
tank, water tray and
NanoCloud rotary
humidification wick
Note
• Cleaning the water tank, water
tray and NanoCloud rotary
humidification wick every week to
keep them hygienic.
1
Pull out the water tank (fig. j).
2
Lift the water tray upwards and pull
it out horizontally (fig. k).
3
Take the wick wheel off the wick
support (fig. †).
4
Rinse the water tank, water tray and
NanoCloud rotary humidification
wick under a running tap.
Note
• Do not take the NanoCloud rotary
humidification wick off the wheel
during cleaning.
• Do not scrub the NanoCloud rotary
humidification wick or place it under
direct sunlight.
• If necessary, use a mild detergent to
clean the water tank and water tray.
In this case, rinse the water tank
and water tray thoroughly.
5
Wipe the outside of the water tank
and water tray dry.
6
Place the wick wheel on the wick
support (fig. m).
Note
• When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
EN
13