Cognex In-Sight 8000 Serie Handbuch Seite 6

Precautions
To reduce the risk of injury or equipment damage, observe the following precautions
when you install the Cognex product:
The vision system requires a UL or NRTL listed Power over Ethernet (PoE)
l
power source that is IEEE 802.3af or 802.3at compliant and meets the
following rating requirements:
For In-Sight 8100, 8200 and 8400 series vision systems, it must be
l
rated Class 0, 2, 3 or 4, or at least 6.49 Watts.
For the In-Sight 8505P vision system, it must be rated Class 0, 3 or
l
4, or at least 12.95 Watts.
A non-compliant PoE source creates a risk of fire or shock and can damage
the components. Applicable national and local wiring standards and rules
must be followed.
This product is intended for industrial use in automated manufacturing or
l
similar applications.
The safety of any system incorporating this product is the responsibility of
l
the assembler of the system.
Do not install Cognex products where they are exposed to environmental
l
hazards such as excessive heat, dust, moisture, humidity, impact, vibration,
corrosive substances, flammable substances, or static electricity.
Route cables and wires away from high-current wiring or high-voltage
l
power sources to reduce the risk of damage or malfunction from the
following causes: over-voltage, line noise, electrostatic discharge (ESD),
power surges, or other irregularities in the power supply.
5