Operation - HANSGROHE AXOR Massaud 18020000 Montageanleitung

Attention! The fitting must be installed, flushed and
tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slide the fixation piece including the washer
over the threaded pins and tighten the nuts.
4. Connect the connecting hose / supply pipes to
the isolation valves; cold right - hot left.
The hot and cold supplies must be of equal pres-
sures.
Technical Data
This mixer series-produced with waterdim-
mer (flow limiter)
®
Rate of flow with waterdimmer:
Rate of flow without waterdimmer: 14 l/min 0,3 MPa
Operating pressure:
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temperature: 65° C

Operation

open

English
5 l/min 0,3 MPa
max. 1 MPa
1,6 MPa
max. 80° C
cold
close
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0,15 MPa.
Spare parts (see page 2)
1 spout cpl.
2 diffuseur cpl.
3 handle
4 nut
5 cartridge cpl.
6 flange
7 pop up waste
8 fixing set
9 connection hose 600mm
hot
98652000
97445000
18093000
97157000
96339000
98650000
50001000
13961000
98600000