Leveling The Styler - LG STYLER S3*F Serie Bedienungsanleitung

LEVELING THE STYLER

WARNING
y To reduce the risk of injury to persons,
adhere to all industry recommended
safety procedures including the use of
long-sleeved gloves and safety glasses.
Failure to follow this warning can cause
serious injury or death.
y The appliance is heavy. Two or more
people are required when installing the
Styler. Failure to follow this warning can
cause serious injury or death.
y To ensure that the Styler provides optimal
performance, it must be level. To minimize
vibration, noise, and unwanted movement, the
floor must be a perfectly level, solid surface.
NOTE
Adjust the leveling feet only as far as
necessary to level the Styler. Extending the
leveling feet more than necessary can cause
the Styler to vibrate.
1 Position the Styler in the final location.
Check to make sure it is level.
y All leveling feet must rest solidly on the
floor. Gently push on the corners of the
Styler to make sure that it does not rock
from corner to corner. Make sure there are
no gaps between the front leveling feet
and the floor.
WARNING
y The Styler is heavy. Use two or more
people if installing the rear leveling feet.
Failure to do so can result in back injury or
other injury.
y Keep the Styler upright when moving
and installing it. If you lay the Styler on
its side, refrigerant may leak and cause
the appliance to malfunction.
2 Use the wrench (packaged with the
manual) to turn the leveling feet.
Unscrew the front feet to raise the Styler or
screw in the feet to lower it. If unable to level
the unit using only the front feet, install the two
rear leveling feet by tipping the unit. Do not lay
the unit down to install the leveling feet.
Raise or lower the unit using the leveling feet
until the Styler is level from side to side and
front to back.
CAUTION
Make sure that all leveling feet are
in firm contact with the floor. If the
Styler is used without leveling, it may
fall, causing injury, damage, or product
malfunction.
3 When the Styler is completely stable and
all leveling feet are resting solidly on the
floor, tighten the locking nuts.
locking
nut
INSTALLATION 17