LG STYLER S3*F Serie Bedienungsanleitung Seite 16

16 INSTALLATION
Recommended Installation Spacing
The following clearances are recommended for
the Styler. Although the Styler has been tested for
clearances of 1 inch (3 cm) on the sides and rear,
/
3
16
recommended clearances should be considered
for the following reasons:
• Additional space should be considered for
ease of installation and servicing.
• Additional space might be required for wall,
door and floor moldings.
• Additional space should be considered on all
sides of the Styler to reduce noise transfer.
• Additional laundry appliance spacing should
also be considered.
Installation Spacing for Recessed Area or Closet Installation
There should be at least a little space around the Styler (or any other appliance) to avoid contact with
walls, furniture, or other appliances during operation. Allow a minimum of 1
of the Styler to avoid increased noise or damage.
• For closet installation, with a door, minimum
ventilation openings in the top and bottom
of the door are required. Louvered doors
with equivalent ventilation openings are
acceptable.
Closet Ventilation Requirements
Closets with doors must have both an upper and
lower vent to prevent heat and moisture buildup
in the closet. One upper vent opening with a
minimum opening of 48 sq. in. (310 cm
installed no lower than 6 feet above the floor.
One lower vent opening with a minimum opening
of 24 sq. in. (155 cm
2
than one foot above the floor. One example
shown uses vent grilles in the door.
closet door vent
requirements
) must be
2
) must be installed no more
(3 in.
(7.6 cm)
Vent
48 sq. in.
(310 sq. cm)
Vent
24 sq. in.
(155 sq. cm)
3 in.
(7.6 cm)
7 3/4 in.
(20 cm)
2 in.
(5 cm)
• Minimum vent opening for built-in
installation is 31 ½ sq. in. (200 cm
Built-In Installation
Wall
10 in. (250mm)
18 in. (455mm)
115˚
15.75 in. (400 mm)
2 in. (50 mm)
73.8 in. (1,875 mm)
18 in. (455 mm)
19 in. (485 mm)
24.8 in. (630 mm)
2 in.
(5 cm)
18 in. (46 cm)
in front
inch (3 cm) on all sides
/
3
16
).
2
②
Ceiling
2 in. (50 mm)
1 in. (25 mm)
74,4 in
1 / in. (30 mm)
3
(1.889mm) 16
1 / in. (30 mm)
3
16
①