Weekly Cleaning Of The Milk Carafe - Philips Saeco PicoBaristo SM5479 Benutzerhandbuch

English
14
2 Remove the cup with the drink and place an empty cup under the milk dispensing spout (Fig. 24).
Note: Make sure the milk dispensing spout is pulled out.
3 Press the OK button to start dispensing hot water.
Thorough cleaning of the milk carafe
To clean the milk carafe thoroughly, you have to do the following regularly:
1 Remove the lid of the milk dispensing unit (Fig. 25).
2 Lift the milk dispensing spout out of the milk dispensing unit and remove the milk tube from the
milk dispensing spout (Fig. 26).
3 Remove the milk tube from the milk dispensing spout.
4 Rinse the milk tube and milk dispensing spout with lukewarm water thoroughly.

Weekly cleaning of the milk carafe

The milk dispensing spout consists of 5 components. Disassemble all components once a week and
clean them under the tap. You can also clean all components, except for the milk container, in the
dishwasher.
1 2
3
4
5
1 Milk tube
2 Rubber support
3 Milk frother
4 Milk frother connector
5 Housing of milk dispensing spout
Disassembling the milk dispensing spout
1 Press the release buttons on both sides of the top of the milk dispensing unit (1) and lift the top off
the milk container (2) (Fig. 27).
2 Turn the milk dispensing unit upside down and hold it firmly in your hand. Pull the milk tube off the
support (Fig. 28).
3 Press the release buttons on the milk frother and remove the milk frother from the the rubber
support (Fig. 29).
4 Pull the milk frother connector out of the milk frother (Fig. 30).
5 Rinse all components under a lukewarm tap.
Reassembling the milk carafe
1 To reassemble the milk dispensing spout, follow steps 2 to 4 of 'Disassembling the milk dispensing
spout' in reverse order.
2 Place the milk dispensing spout back into the top of the milk carafe.
3 Place the top of the milk carafe back onto the milk carafe.
Note: Before you place the milk dispensing spout back into the top of the milk carafe, move the pin
inside the top to the correct position. If this pin is not in the correct position, you cannot place the milk
dispensing spout back into the top of the milk carafe (Fig. 31).