Accessories - Truma DuoComfort Gebrauchsanweisung, Einbauanweisung

– Connect DuoComfort directly
to the regulator; if necessary
use the Truma angle union
(part no. 50020-56000) or the
Truma extension kit (part no.
50020-61100).
– Attach to the wall with two
screws.
– Screw high-pressure hoses to
the DuoComfort inlets, using
angle unions (part no. 50020-
56000) if necessary.
– After installation is complete,
check the hose connector to
the changeover valve's inlet
and the connection to the
adjacent regulator for leaks
(using, for example, a leak-
detection spray according to
DIN EN 14291).
This test does not replace
the regularly scheduled
gas check!
16

Accessories

High pressure hoses
(with hose-break safety device)
see page 58 – 59
1.5 meter connection hose
for connecting external gas
cylinders
(G.5; part no. 50020-61300)
Replacement gaskets
for high pressure hoses
(G.13 or M20 x 1.5;
part no. 50020-76300)
Remote display
(including EisEx)
Shows the removal status from
inside the vehicle
(part no. 50210-01)
EisEx, regulator heating
(part no. 53101-01)
Angle union 90º
(part no. 50020-56000)
Extension kit
required when gas cylinders
separated by more than 100 cm
(part no. 50020-61100)
Gas remote switch
For turning off the gas supply
from inside the vehicle
GS 8 (part no. 57013-01)
GS 10 (part no. 57023-01)
Screw aid
(part no. 50020-61500)