Sony BVF-20W Handbuch Seite 20

Location and Function of Parts
1 Plug
Connect to the VF connector on the camera.
2 Stopper
Prevents the viewfinder from coming off the camera
when it is slid from side to side.
3 Tally indicator (rear)
Lights up when the camera receives a tally control
signal. This indicator can be covered when not in use.
4 Diopter adjustment ring
Allows for optimal adjustment of focus.
5 Tally indicator (front)
Lights up when the camera receives a tally control
signal. Turn the TALLY switch 9 OFF when not in
use. The brightness can also be adjusted with the
TALLY switch 9.
6 PEAKING control
Turning this control clockwise adjusts the picture
sharpness, and makes focusing easier. This control has
no effect on the output signals of the camera.
7 CONTRAST control
Adjusts the contrast of the screen. This control has no
effect on the output signals of the camera.
8 BRIGHT control
Adjusts the brightness of the screen. This control has
no effect on the output signals of the camera.
9 TALLY switch
Controls the tally indicator 5 located on the front of
the viewfinder.
HIGH: The tally indicator brightness is set to high.
OFF: The tally indicator is disabled.
LOW: The tally indicator brightness is set to low.
4(E)
0 ZEBRA (zebra pattern) switch
Controls the zebra pattern display on the viewfinder
screen as follows:
ON: A zebra pattern appears and stays.
OFF: The zebra pattern disappears.
MOMENT: A zebra pattern appears and stays for
about five seconds.
qa DISPLAY switch
Enables or disables the marker indication when the
indication is set to on with the camera.