Cleaning (see page 11) Gloves should be worn during installation to prevent crushing and cutting injuries. Maintenance (see page 11) The hot and cold supplies must be of equal The check valves must be checked regularly according pressures. to EN 806-5 in accordance with national or regional Installation Instructions regulations (at least once a year). • Prior to installation, inspect the product for transport Operation (see page 10) damages. After it has been installed, no transport or surface damage will be honoured. • Do not rotate the spout further than 360º or damage • The pipes and the fixture must be installed, flushed to the hose will result. and tested as per the applicable standards. • Hansgrohe recommends not to use as drinking water the first half liter of water drawn in the morning or • The plumbing codes applicable in the respective after a prolonged period of non-use. countries must be observed. Technical Data Operating pressure: max. 1 MPa Recommended operating pressure: 0,1 - 0,5 MPa Test pressure: 1,6 MPa (1 MPa = 10 bar = 147 PSI) Hot water temperature: max. 70°C Recommended hot water temp.: 65°C Thermal disinfection: max. 70°C / 4 min...
Seite 3
Warmwasseranschlüssen müssen ausgeglichen Wartung (siehe Seite 11) werden. Rückflussverhinderer müssen gemäß EN 806-5 Montagehinweise regelmäßig in Übereinstimmung mit nationalen oder • Vor der Montage muss das Produkt auf Transport- regionalen Bestimmungen auf ihre Funktion geprüft schäden untersucht werden. Nach dem Einbau werden (mindestens einmal jährlich). werden keine Transport- oder Oberflächenschäden Bedienung (siehe Seite 10) anerkannt. • Auslauf nicht weiter drehen als 360º, da sonst der • Die Leitungen und die Armatur müssen nach den Schlauch beschädigt werden kann. gültigen Normen montiert, gespült und geprüft werden. • Hansgrohe empfiehlt, morgens oder nach längeren Stagnationszeiten den ersten halben Liter nicht als • Die in den Ländern jeweils gültigen Installationsricht- Trinkwasser zu verwenden. linien sind einzuhalten. Technische Daten Betriebsdruck: max. 1 MPa Empfohlener Betriebsdruck: 0,1 - 0,5 MPa Prüfdruck: 1,6 MPa (1 MPa = 10 bar = 147 PSI) Heißwassertemperatur: max. 70°C Empfohlene Heißwassertemperatur: 65°C Thermische Desinfektion: max. 70°C / 4 min Das Produkt ist ausschließlich für Trinkwasser konzipiert!
Seite 4
(3 Nm) 150° SW 24 mm SW 10 mm (4 Nm) 110°...
Seite 5
150° 75° 75° 24 x 15° 45° 105° 105° 45°...
Seite 6
110° 110° 55° 55° 24 x 15° 25° 85° 85° 25°...