Changing The Motor Protection Filter - BVC C 600 DE Bedienungsanleitung

central vacuum cleaner
operation manual
Care instructions
Attention:
Always disconnect the main power plug prior to servicing or cleaning your BVC central
vacuum cleaner.
When required, clean the main unit of the BVC central vacuum cleaner with a soft cloth.
Never use solvents or strong cleaners.

Changing the motor protection filter

We recommend that you clean the motor protection filter once a year or completely replace
the filter.
To guarantee a smooth removal and installation of the filter, remove the dust container and
the filter bag as described on page 50. Then dismount the BVC central vacuum cleaner, turn
it upside down and put it on an even surface.
The spring tension ring must be pulled with the loop towards the center (see picture 1).
This will cause the filter to deform which is necessary for the removal.
1
2 3
seam
Make sure that the motor compartment is entirely free of dust and dirt particles.
Dust and dirt can damage the motor!
To insert the filter, the filter must be formed to a semi-circle (see picture 2) and be placed
gently into the seam (see picture 3). The spring tension ring needs to spring back into its
original form. The remaining bend needs to be pressed into the seam. You should hear a
snapping sound.
BVC EBS Distribution GmbH assumes no liability for damages on the BVC central
vacuum cleaner due to wrongful installation and/or removal of the filter.
© 2016 BVC EBS Distribution GmbH, Schweinfurt
51